EMachines Flat Panel Monitor Guide de l'utilisateur télécharger pdf (Page 15)

www.emachines.com

Setting up the optional speaker bar

Installing the speaker bar

To install the speaker bar:

1 Tilt the screen back, then center the speaker bar below the screen. Make sure that the

speakers face forward.

2 Tighten the two thumbscrews on the back of the speaker bar.

3 Connect the speaker bar’s USB power cord to any available USB port on your computer.

4 Connect the speaker bar’s headphone (green) and microphone (pink) cables to your

computer’s headphone and microphone jacks.

5 If your computer is not already on, turn it on.

Tip (19-inch model)

When using the optional speaker bar, we recommend that you use the

included right-angle VGA cable for the video connection so the speaker bar does not

obstruct the cable. In the United States, if you are using a DVI connection, you can

order a right-angle DVI cable from www.gateway.com

Power/Volume control

Power indicator

Kensington lock slot

Headphone jack

Bass port (for bass sound. Do not block.)

Microphone jack Headphone jack

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Pas de commentaire

EMachines Flat Panel Monitor Guide de l'utilisateur Page 15