Emachines Notebooks Manuel d'utilisateur télécharger pdf (Page 54)

getting started

battery

To remove and install a battery:

1. Power off your notebook and close the display. Disconnect all cables,

including the AC power adapter, modem, and network cables.

2. Place your notebook upside down on a stable work surface.

3. To remove an existing battery pack, slide and release the battery release

button 1. The battery will pop up. Grasp the raised edge of the battery pack

and lift it out of the battery compartment 2.

Before performing any of the procedures in this section,

follow industry-standard practices for preventing

electrostatic discharge. See the Warning note at the

beginning of this chapter for more information.

There is a danger of explosion if this battery is incorrectly

replaced. Replace with the same or equivalent type

recommended by eMachines.

AACR53700001K4.book Page 56 Friday, September 5, 2003 1:52 PM

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 77 78

Pas de commentaire

Emachines Notebooks Manuel d'utilisateur Page 54