EMachines D620 Informations techniques Page 82

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 118
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 81
92 Chapter 4
Index of Error Messages
Error Message List
Error Messages Check or do the following in sequence:
Stuck Key See “Keyboard or Auxiliary Input Device Check” on page 88.
System CMOS checksum bad - Default
configuration used
RTC battery.
Run the BIOS Setup Utility to reconfigure the system time,
then reboot system.
Real time clock error
RTC battery
Run the BIOS Setup Utility to reconfigure system time, then
reboot system.
Mainboard
Previous boot incomplete - Default
configuration used
Run “Load Setup Defaults” in BIOS Setup Utility.
RTC battery
Mainboard
Invalid System Configuration Data
Run “Load Setup Defaults” in BIOS Setup Utility.
Mainboard
Operating system not found
Run the BIOS Setup Utility to check if the fixed disk and drive
A are properly identified.
CD/DVD-ROM drive
Hard disk drive
Mainboard
Power-on indicator turns off and LCD is
blank.
Power source (battery pack and power adapter.) See “Power
System Check” on page 89.
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM
Mainboard
Power-on indicator turns on and LCD
is blank.
Power source (battery pack and power adapter.) See “Power
System Check” on page 89.
Reconnect the LCD connector
Hard disk drive
LCD cable
LCD inverter
LCD
Mainboard
Power-on indicator turns on and LCD
is blank. But you can see POST on an
external CRT.
Reconnect the LCD connectors.
LCD cable
LCD inverter
LCD
Mainboard
Power-on indicator turns on and a
blinking cursor shown on LCD during
POST.
Ensure every connector is connected tightly and correctly.
Mainboard
Failure Fixed Disk
Reconnect the hard disk drive connector.
Run “Load Setup Defaults” in BIOS Setup Utility.
Hard disk drive
Mainboard
Vue de la page 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 117 118

Commentaires sur ces manuels

Pas de commentaire